Reference to the preparation of aluminum conductors:
Clean the bared conductor end carefully by scraping off the oxide film, for example with a knife, (Please do not use rasps, emery paper or brushes!).
Immediately after removing the oxide film the conductor end is to rub in with acid and alkali free fat for example vaseline, and immediately to be connected in the terminal.
The prementioned processing steps are to be repeated, if the conductor was disconnected and connected again.
Due to the disposition to flowing of aluminum the terminals are to be re-tightened before start-up and after the first 200 operation hours.
rated connecting capacity
3~ 10-95 mm�
conductor material:
Prior to connection, aluminium conductors must be prepared according to the relevant technical recommendations.
Cu/Alu
Polarity
5-pole, per pole
conductor cross section
2 x 10-95 mm�
conductors can be inserted from the front into the clamping unit
terminal technology, see annex DK Cable junction boxes
conductor cross section
Cu/Alu, sol (round) 2 x 10-50 mm�
Cu/Alu, s / f (round)
2 x 16-95 mm�
Cu/Alu, sol (sector) 2 x 50-95 mm�
Cu, s (sector) 2 x 35-95 mm�
is the Exclusive Importer of HUMMEL products. We offer over 6,000 different Types and Sizes of RoHS Compliant Liquid Tight Strain Relief Fittings, Cord Grips, Cable Glands, Circular Connectors, Conduit System, Industrial Enclosures and Other Related Cable Management Products which are rated the best in the industry.
7374 S. Eagle Street
Centennial, CO 80112-4221 USA
Toll Free: 800-456-9012 / 303-699-1135 FAX: 303-680-5344
Enclosures: IP Rated
Thermoplastic: D & K Series 
Hinged
