VNTC | Vinyl Nylon Tray Cable Control Cable

Sealcon, Inc, European & Domestic cable

VNTC UL/CSA | Vinyl Nylon Tray Cable Control Cable

Printable PDF

APPLICATIONS AND FEATURES

Sealcon Vinyl Nylon Tray Cable (VNTC) 600 Volt Type TC-ER control cables from Sealcon are suited for use in wet and dry areas, conduits, ducts, troughs, trays, direct burial, aerial supported by a messenger, and where superior electrical properties are desired. These cables are capable of operating continuously at the conductor temperature not in excess of 75°C in wet locations and 90°C in dry locations, 130°C for emergency overload, and 150°C for short circuit conditions. For use in Class I, II, and III, Division 2 hazardous locations per NEC Article 501 and 502. Constructions with 3 or more conductors are listed for exposed runs (TC-ER) per NEC 336.10. Silicone Free.


SPECIFICATIONS:

• ASTM B3 Standard Specification for Soft or Annealed Copper Wire
• ASTM B8 Concentric-Lay-Stranded Copper Conductors
• UL 83 Thermoplastic Insulated Wires and Cables Type THHN
• UL 1277 Electrical Power and Control Tray Cables
• UL 1685 FT4 Vertical-Tray Fire Propagation and Smoke Release Test
• ICEA S-58-679 Control Cable Conductor Identification Method 1 Table 2
• ICEA S-73-532 Standard for Control
• ICEA S-95-658 (NEMA WC70) Power Cables Rated 2000 Volts or Less for the Distribution of Electrical Energy
• IEEE 1202 FT4 Vertical Tray Flame Test (70,000 Btu/hr) and ICEA T-29-520 - (210,000 Btu/hr)
• Voltage Rating: 600V (Type TC-ER)
• Operating Temperature: -40°C to 90°C (-40°F to 194°F)
• Jacket Material: Polyvinyl chloride (PVC) jacket
• Filler: Polypropylene filler on cables with 5 or less conductors
• Binder: Polyester flat thread binder tape applied for cables with more than 5 conductors
• Conductor Markings: Control Cable Conductor Identification Method 1 Table 2
• Temperature Rating: 75°C (167°F) Wet, 90°C (194°F) Dry Flame Rating: FT4
• Approvals: UL (E75755)

1. Conductor: 7 strands class B compressed bare copper per ASTM B3 and ASTM B8 for 14, 12, and 10 AWG cables. 26 strands class K bare copper per ASTM B3 and B174 for 16 AWG cables.
2. Insulation: Polyvinyl Chloride (PVC) with nylon layer 19 Mils thick for 18, 16, 14, 12 AWG cables and 24 Mils for 10 AWG cables, Type TFFN/TFN for 18 and 16 AWG cable and Type THHN or THWN for 14, 12 and 10 AWG cables.
3. Filler: Polypropylene filler on cables with 5 or less conductors.
4. Binder: Polyester flat thread binder tape applied for cables with more than 5 conductors.
5. Overall Jacket: Polyvinyl Chloride (PVC) Jacket

Printable PDF

For questions or to place a order please call 1-800-456-9012 Or Email